Recent content by adamk44

A
SCSI Newbie

Update: I've updated the drivers for the SIS Chipset in my ASUS P4S8X MoBo, and my benchmark results changed substantially, but they are still not right. I used Atto, Sandra, and HD Tach - they all gave me similar results: Benchmark Breakdown Buffered Read : 2816 MB/s Sequential Read : 42...
- adamk44
- Post #18
- Nov 4, 2003
- Forum: Computer Building
A
SCSI Newbie

Thanks, I'm pretty sure that this was fixed by SP1 This is interesting: http://forums.storagereview.net/index.php?showtopic=10199&hl=21320 This person had the exact same hardware configuration, and the exact same problem. For him it turned out to be the wrong type of terminator. I purchased...
- adamk44
- Post #17
- Nov 4, 2003
- Forum: Computer Building
A
SCSI Newbie

Yup, I went over the instructions over 5 times
- adamk44
- Post #15
- Nov 3, 2003
- Forum: Computer Building
A
SCSI Newbie

SCSI ID 0 is set to 320 in the SCSI BIOS Who should I contact for support on this issue, Adaptec or Seagate?
- adamk44
- Post #13
- Nov 3, 2003
- Forum: Computer Building
A
SCSI Newbie

http://www.seagate.com/support/disc/iguides/scsi/100148125b.pdf According to the manual, no jumper = auto-select LVD or SE. I have no jumpers on the drive at all. Where / how would I change the SCSI mode (ie Ultra3, Ultra160, Ultra320)?
- adamk44
- Post #12
- Nov 3, 2003
- Forum: Computer Building
A
SCSI Newbie

SCSI ID is 0 Controller ID is 7 My most recent sequential read is up to 54MB/s, but the rest of the numbers still range from 18-24 MB/s
- adamk44
- Post #10
- Nov 3, 2003
- Forum: Computer Building
A
SCSI Newbie

Using HD Tach my average read speed is 34.6 MB/s
- adamk44
- Post #7
- Nov 3, 2003
- Forum: Computer Building
A
SCSI Newbie

Ran the seagate utility (seatools) drive checked out fine. In the device manager the adaptec drivers are listed correctly. However, there are 6 unknown devices that popped up after I installed the HD / controller. I disabled them because I have no idea what they are. Just discovered that...
- adamk44
- Post #5
- Nov 3, 2003
- Forum: Computer Building
A
SCSI Newbie

I have an Asus P4S8X MoBo & I downloaded the latest driver from the adaptec website
- adamk44
- Post #3
- Nov 3, 2003
- Forum: Computer Building
A
SCSI Newbie

I recently purchased a Cheetah 15K.3 SCSI HD (ST336753LW) & a Adaptec 29320-R Controller. I have two problems which may or may not be related. Issue 1: When I Cold boot or restart my machine, after the Windows XP Boot Logo, sometimes it goes into windows, and sometimes it restarts again...
- adamk44
- Thread
- Nov 2, 2003
- Replies: 17
- Forum: Computer Building

RESOURCES

Top Bottom