I don't think it was using all 32 cores and 64 threads through the encoding process. I remember this version of handbrake not using all cores threads of higher core count CPUs in the past. When I ran the encoding again, I opened up task manager and go to the performance tab, the CPU...
https://www.newegg.com/team-group-mp33-1tb/p/N82E16820331417
Not the fastest PCIE 3.0x4 NVMe SSD, but if you need something for a low price its not a bad deal.
Consumer grade mass produced temperature sensors aren't the most accurate. I've seen two sensors of the same model show a 1C difference between them when in the same location. They are usually consistent, but not accurate. So that makes it difficult to accurately compare differences.
The...
Is this one close enough?
Its a few mm away from the radiator. Much closer and it would be touching.
I have one after the radiators and before the pump. I didn't think that the data would be that relevant because the pump speed, fan speed, and ambient air temperature were the same for all...
I have a temperature sensor behind the dust filter on the front of the case. The sensor reports between 25.5C and 26.5C with the front door of the case open. It seems to be consistent and rarely varies when I set the fans to a fixed speed and the front door open. If I were to use that...
I tried taking out the GPUs and putting in the GT 1030 I have in their place. Then I reconnected the the tubing with the EKWB/CLC quick disconnect fittings i had in place to make removing the GPUs easier. I ran AIDA64, Prime95 small FFT and Intel Burn Test on the Very High preset. The...
I've seen a single D5 pump powering systems with three radiators, a GPU block, and the Intel version of the Optimus CPU block without any issues. With my GPU blocks in parallel, their pressure drop total should be the same as a single GPU block according to every reliable source I could find on...
The EX Supremacy EVO seems to be average to above average for restriction or below average in flow rates among CPU block flow rates based on the tests I've seen depending on the version. The x99 version flowed better and had less pressure drop than the 1151 version.
I'm not sure if I agree...
I did a comparison of the Optimus Foundation AM4 block to the Corsair XC7 RGB CPU block in the same system.
When I built my open loop, the Optimus Foundation AM4 block I ordered was on back order. I wasn't going to wait an unknown amount of time for the CPU block to arrive to wait to finish...
I've been told that there are a few Gigabyte motherboards that have this feature. However with my past experiences with their warranty/RMA service I stopped buying their products. What good is a product if the warranty is 100% completely useless?
My old Asus Z170 chipset motherboard had the USEF/BIOS option to control fan headers based on CPU temperature or several other device temperatures. One of them was the temperature of the device in the PCIE x16 #1 or PCIE x16 #2 slot.
This was useful to me in my old Z170 6700K system because I...
I've done my own tests with a SATA-III 2.5" SSD, PCI Express 3.0 x4 NVMe SSD, and PCI Express 4.0 x4 NVMe SSD. The time differences for most games in game loading times and level loading times were so small that I needed to go into the video and measure the time using Adobe Premiere to measure...
3950X @4.2 GHz
32GB DDR4 3600 MHz
Windows 10 Pro
The difference from previous results was that I left the front door of the Fractal Design Define R6 case open to allow more airflow. The CPU stayed cooler and didn't reduce speed as often to maintain temperature which gave me higher results...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.