Recent content by bgbass

B
ASUS a7n8x & xp3000

Roger that! Happy Halloween.
- bgbass
- Post #9
- Oct 31, 2003
- Forum: Computer Building
B
ASUS a7n8x & xp3000

JS, I tried your suggestion and went back to bios 1.06. After getting the machine to post and windows finally loaded, something quite interesting happened. " Windows has found new hardware - NVIDIA PCI memory controller. " I rebooted, set the correct fsb & clock and it's running as smooth as...
- bgbass
- Post #6
- Oct 30, 2003
- Forum: Computer Building
B
Classic processors homework

Three bonified classics; the 386, the AMD K6-2 and the original Pentium Pro. In fact check out this link on the Pro http://www.pcguide.com/ref/cpu/fam/g6PPro-c.html
- bgbass
- Post #18
- Oct 29, 2003
- Forum: Computer Building
B
ASUS a7n8x & xp3000

Thanks for the reply. I initially set it up @ 200 X 10.5 When it did finally boot. It would run for about 2 minutes before a crash and a reboot. The crashes usually begin with the display going corrupt. The ram is: 2 X 512 Corsair 3200C and the timings are 2.5-3-3-8. ( I reduced the...
- bgbass
- Post #4
- Oct 29, 2003
- Forum: Computer Building
B
ASUS a7n8x & xp3000

Thanks for the reply. I initially set it up @ 200 X 10.5 When it did finally boot. It would run for about 2 minutes before a crash and a reboot. The crashes usually begin with the display going corrupt. The ram is: 2 X 512 Corsair 3200C and the timings are 2.5-3-3-8. ( I reduced the...
- bgbass
- Post #3
- Oct 29, 2003
- Forum: Computer Building
B
ASUS a7n8x & xp3000

Hello all, I just purchased the XP3000 (4oomhz) cpu to put in an A7N8X-dx. For some reason, the highest that I can get the chip to post and remain stable is XP2800 (2.09 Ghz). The motherboard REV is 1.04 and the bios is 1.07 (the lastest). On a side note, the multipliers in my bios only go up...
- bgbass
- Thread
- Oct 29, 2003
- Replies: 8
- Forum: Computer Building
B
A7N8X Sata issues...

Racer & sh4nsen, Thank you for the tips. I tried to boot from the cd-rom w/ XP. It attempted to install itself but failed when it could not find a hard disk. I did get a prompt for installing 3rd party drivers, but only from the A drive. After the failed installation, I got a DOS prompt. I...
- bgbass
- Post #4
- Oct 15, 2003
- Forum: Computer Building
B
A7N8X Sata issues...

My A7n8x will not boot from a RAID 0 configuration. Hopefully someone out there can offer some info. The scenario: I recently installed 2 WD raptors and setup a Raid 0 configuration. I was able to image my current drive to the Raptor drive(s). All the data/partiontions/info seem to be intact...
- bgbass
- Thread
- Oct 14, 2003
- Replies: 3
- Forum: Computer Building

RESOURCES

Top Bottom