I have a 4TB Raid5 setup with my SB750 chip set. I was writing a 4gb file from a separate (non raid) hard drive to the raid drive and it started to write at 65 MB/s for about 10 seconds and then it started to slow down to 19MB/s. Is this normal?
I know on-board raid performance isn't as...
I've got 5 Seagate 7200.12 1TB disks in Raid 5. I'm running Windows 7 on a separate disk. My write speed for the raid 5 is really slow I get an avg of 15MB/s according to Barts Stuff test. Is this normal or should I be getting better performance?
I am using the on board raid controller...
I got the unknown device to go away and I got the three buttons on the side to work. I installed some of the drivers from the hp site.
The only thing that I cannot get to work is the multi touch...actually I'm not sure how to check that it works. When I go into HP's software suite and use the...
I got a new tx2z-1300cto laptop. I formatted the computer and installed a fresh copy of Windows 7. Windows 7 installed most of the drivers itself. I manually installed the multi touch / touch screen driver from the ntrig site ( http://www.n-trig.com ) but multi-touch is not working. In my hp...
I have a Asus m3a78t 790gx/sb750. I want to build a raid setup with 3 Seagate 7200.12 1tb drives. What is the max amout of drives the sb750 chipset can handle in a raid 5 setup?
If I wanted to add another 1tb drive to the raid 5 setup without loosing data, is the possible on the sb750 ?
I'm looking to invest in a new cooler but then I found my TT Big Typhoon and the only thing I'm missing is the am2 bracket. I'm trying to look on the net to see if I get it somewhere. I called up TT and they want $25 just for the bracket....Screw that!
I followed the sticky to "Isolate and...
I'm currently using the stock heat sink but my temps are high. At first I might have put a little too much Arctic Silver 5 so I took off the heat sink, cleaned both surfaces, and used the "grain of rice" method with AC5. Right now I'm running my PHII at 3.6ghz 1.52v. Idle temps are ~41c and...
Looks like 200x18 with 1.52v 2ghz NB, 1.8ghz HT, is all I can get. I couldn't even do 3.5ghz at 1.35v stock. Temps are a bit high, 40c idle and 70c full load. I was looking into a few coolers and I've seen so many TRUE 120 recommendations.
Whats the main difference between TRUE 120, TRUE...
The only way I could get 3.6ghz was to up the voltage to 1.55v. Also I put in a old ATI x1950xt card that I found and I still cant pass 3.6ghz.
I couldnt do 3.5ghz at stock either.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.