Not so...
You can down clock all retail Conroes if the board manufacturer writes it in his bios...
Currently the Gig.DS3 lower multipliers work fine with both the 6600 & 6700 Conroes.
So it's very likely the P5B 507 bios will also support it...
The board is currently trash if you're running conroe... Bios completely hosed, so bad it even makes the DS3 look good, and that's hard to do...
Check here:
http://www.xtremesystems.org/forums/showthread.php?t=110054
Disconnect the modem for 30mins or so... Just resetting isn't enough. Most cable modems are set up to assign one ip to a specific mac address.... Once you change NICs the mac has changed so you need to leave the modem unplugged long enough for it to lose that assignment and acquire a one from...
You're best to start testing and see what works for you and what you're trying to accomplish... The timings I suggested are conservative, safe, and should produce a stable/reliable system. If you are more interested in BenchMarking then start tweaking settings and testing with SuperPI, Everest...
Bad assumption, totally different chipset; as well as A64 Tweaker doesn't work well with the RD580 chipsets, additionally alot of the A64 tweaker displayed settings aren't accessible in the A8R32 bios...
These work up to 'bout 270 @ 2.60volts
CAS 3.0
TRAS 8.0
TRP 4.0
TRCD 4.0
TRRD 2T
TRC 8T
TRFC 16T
TRWT 4 CLK
MCT Extra Timing mode Auto
User Config Manual
Read Preamble 5.5ns
Async Latency 7.0ns
CMD-ADDR Timing 1T
Bank...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.