This is interesting as I am not experiencing this problem at all.
I installed 3 GE-Z-wave switches (technically 4 as one is the add-on switch for 3-way but that one is basically dumb) last Thursday. Set them up in a group, and created a robot so that if the 3-way switch is activated, the...
But did you put in new batteries. I was having all of those issues, and it was reporting the battery was good when it was working. I swapped the battery anyways and everything works great now.
actually wanted the traditional wired SPST (Single Pole Single Throw Switch (Hardwired)) that is wink/zwave enabled so that I could use that to remotely open/close the antique garage door opener for the next few months until I replace the garage door and garage door opener.
Thank you Haljalika, I am waiting for that kit to show up too so at least now I know what to expect.
As far as the android app experience (good thing I have an iOS device as a backup I guess), that sounds like a update is clearly needed. I wonder if Matt-WINK knows of this. Did you report it...
Did you replace the battery. I thought one of my trippers was busted, it seems they aren't reporting low battery properly. New battery and it works awesome again.
Also, for those who haven't done it yet (as I saw a few people mentioned it here on the forum (I'm new and was reviewing)), you can now take Day 0 hubs (ones that were never hooked up and stuck in the box) and update them to the latest firmware using the recovery.wink.com instructions. I did it...
It's in the app but not on the wink page yet. Wink works with Pella products. Using If you have a Pella Bridge, then Pella makes a Tilt sensor specifically for garage doors that works with wink, if you have the bridge.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.