ok now after i unplug the raptor and install windows the raptor shows up as c: but now the 250 gig hd shows up as f: drive. my dvd rom/burner are now D: and E:
any ideas on how to make my hard drives show up as C: and D:.... raptor being C: and 250 maxtor showing up as D:? is there...
ok yea.... i was thinking that would be my last resort. but if that's the way it's gotta be done then i'll do it that way then. thanks for the input. i'll try it and see what happens.
i just bought a western digital 74 gig SATA raptor hard drive. i also have a maxtor 250 gig PATA hadr drive.
I am trying to install windows on my raptor drive and have my 250 maxtor show up as the D: drive. However, the opposite is happening. when i go to install windows, it asks me to...
can I buy any brand/type of ram for a Dell computer? For example a GX270 takes PC3200 ram.
but can i stick in any type or different brand of ram for this as long as it's PC3200? dell suggests to use kingston, but only gives you a few options for compatible ram from kingston. I want to...
well i dropped my voltage down to 1.5 V..... (no problems) started running prime95 again and within a couple of minutes it starts getting up to 58C. i touched my heat sink and it only feels warm.
did i not put on my AS5 right? i put only a little in the middle of the cpu and smashed it...
i don't think it's the ambient temp because i started it at 12 AM Sunday night (about 60 F).... checked at around 11-12 PM Monday morning.... and the 2nd time i checked was at 8-9 PM when it was pretty cool (60-70 F again). i turned it off at 10 PM. i'm just not sure why all of the sudden it...
thanks for all your replies
i guess i should've stated the HSF i was using on my processor. it's an arctic cooling silencer ultra 64 which is a little better than the stock HSF.
what's strange was it was running at 52 C at the 12 hour mark.... I thought that was the highest it would go...
i have a 3200 venice overclocked to 2.6 ghz at 1.525 V. arctic silver 5 is on with a ok hsf.
after playing a hour of half life 2 my cpu runs at 50 C... it idles around 42 C. however, after running prime95 for 22 hours without an error my cpu is at 59 C? is that too hot??? is this normal...
thanks for the answer... would it reduce the lifespan of the board if i run it a lot over 1k for a long period of time? i'm at 2.61 Ghz right now... maybe thinking of going to 2.7. so that would bump my HT to 1080.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.