So, I have it figured it out now. That hex nut is a bleeder and that other silver stud is a check valve that can removed to fill the reservoir. This was missing a copper crush washer and fluid leaked from here. All good now.
Good ideas, thanks. I have not seen a video on bleeding this type of valve body and was expecting to see a fill port but there isn't one. I think that large hex nut is a bleeder though so that's a start.
Yes fluid has leaked out that seal on the valve body where the release actuator is. I'll...
I think it needs bleeding/filling because only that last part of the pedal stroke provides pressure plus it doesn't want to go all the way up. I did find a label on it but the company is out of business. (Hydraulique Lift G Jepsen International Ltd. Imported by Lift Buddy Canada Distributors...
Hello,
I have this motorcycle lift table that needs bleeding and I can't figure out where to bleed it from. Can anyone tell from these pictures where to start? I don't see a port on the red cylinder and figure there must be a way with the caps on the black valve part but so far I've had no...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.