I have the 8rda+ and these boards are very picky about what memory is used. Also SP1 should be installed before installing the 2.03's. Temp's look a bit high to me, my cpu usually runs about 10c above case temp with MBM5. Idle 39C to Load 45C on my 2100XP. You may need to bump the voltage a bit...
I went into C:\Program Files\Messenger\ and rename msmsgs to msmsgs.old
Some of the other methods can cause your email program to hesitate on startup. Found that out the hard way.
I have two sticks of Twinmos 3200 in my 8RDA+ and it works fine. Less expensive than Corsair. Very Satisfied with this board, but then again I moved up from a K6-2+ so I probably would have been happy with anything.
I have this drive and I am using Nero 5540. Nero 5535 supports this drive as well. I too have a Plextor re-badge and would like to add Plextor firmware but haven't been able to locate enough information to do so.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.