I have a slight problem with my board
I got a new new CPU after the original one didn't post atall and just gave me long beeps.
I turned it on and I had left the jumper on the board accidentely on the CPU 133mhz and it displayed P4 2.4Ghz whereas it is a P4 1.8Ghz.
It then displayed 'CMOS...
thats what i been doing.
Had the board completely out of case on anti-static mat and the monitor plugged into the onboard video, RAM installed and CPU. Thats it. Still all i get is the fans going, so power is okay, but no video and Post Codes should light up on the Epox.
Is it possible its the...
i do a lot of recording tapes to PC and then onto CD because of the type of music i listen too, most comes on tapes.
I use a program called Sonic Foundry Sound Forge 6.0 but it aint free. You could try and download from one of these P2P programs.
This is a very good music editor and all I have...
first of all i bought the 4G4A+ board with P4 1.6A Northwood over 2 months ago. I also ordered Samsung PC2700 RAM and Antec SX635 case.
After waiting 2 weeks I was sent the old P4 1.6 chip so sent back. They then decided to send me the same wrong chip again. I finally told them the chip is no...
Is it okay to use the foam pad that comes with the board for packaging??
It covers the whole bottom of the board
its not going to get hot and burn is it??
I have a 4G4A and put into an Antec SX635 case but all i get is a constant beep and no display.
So after trying different RAM I took board out and it booted up okay.
Tried putting back in but it just keeps shorting.
I am using the gold screw into the case and then normal screws into that, which...
personally i would buy yourself an amp, anything under $100 should do. preferrably well known make.
and get yourself some good stand mount speakers around $100 should be okay
i am running Kef Cresta 2 speakers with a Cambridge Audio A1 V2 which totalled £150 which in dollars is about $90 i...
the only thing in manual is the post codes that display on the motherboard indicator
when i switch PC on I dont get any codes show up???
i think i will RMA the board
I have just tried using 1 stick in every slot
tried both sticks of RAM this way and still beeps
i am sure the RAM is okay as I tried in 8K7A board and it was working
Can anyone help me out
just installed 4G4A+ with P4 1.8A using onboard video, Antec SX635 case, Samsung 2x 256Mb PC2700 RAM.
When I turn it on, no screen appears and about 3secs later a constant beeping occurs. No code shows up on board atall.
So i tryed different CPU bus speed settings...
Just installed this Epox 4G4A+ board with P4 1.8A Northwood and Samsung 2x 256Mb PC2700 RAM currently using onboard video.
SO i used Artic Silver 2 and set it 2 days ago. Made sure I did a good job.
I know the RAM works because I have used it in my 8K7A board previously.
So after I turn it on...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.