Recent content by MulLa

M
CCME SIP Trunk Connectivity Issue

Hi all, Long story short, I have a 1760-V running CCME 4.1 and recently subscribed to an online VoIP provider, just trying to get the two intergrated so I can make calls via CCME. At the moment I can't make any calls via SIP, I currently have it setup so I dial "0" to get a POTS line...
- MulLa
- Thread
- Oct 9, 2008
- Replies: 0
- Forum: Networking
M
QoS router, works across multiple switches?

If your router supports QoS you might be able to apply QoS on your out going traffic, but then you will not have the ability to control incoming traffic. So I would doubt you're going to see any noticeable effects.
- MulLa
- Post #8
- Jul 22, 2008
- Forum: Networking
M
Port Forward on an ASA

Thanks heaps in advance guys for the help! Below are various "shows" and the full congif. Sorry this is a little long. As mentioned before, this is a lab environment thus all IPs are private ranges. 10.96.253.71 <- this is the box that we're TS'ing from. ASA1# sh xlate detail 1 in...
- MulLa
- Post #8
- Jul 21, 2008
- Forum: Networking
M
Port Forward on an ASA

Hi Guys, really appreciate the assistance. I have tried the packet tracer if I have the destination as the outside ASA interface everything checks out. If I have the destination as the TS box then the NAT rule seemed to be dropping packet. I really don't understand why it's dropping packets...
- MulLa
- Post #6
- Jul 21, 2008
- Forum: Networking
M
Port Forward on an ASA

Thanks nightowl, I think I remember seeing your name from way back ;) I certainly didn't think about the inside access list, but upon further inspection, the inside list seemed to be an allow all list as follows. access-list outside_access_in remark Inbound Access from Outside access-list...
- MulLa
- Post #3
- Jul 21, 2008
- Forum: Networking
M
Port Forward on an ASA

Hi All, Haven't been here for a while, things looked a little quiet compared to a few years back :P Anyway, hope someone can point me in the right direct in regards to port forwarding RDP traffic on an ASA. For the life of me I couldn't work out why the below config isn't working, I can...
- MulLa
- Thread
- Jul 21, 2008
- Replies: 7
- Forum: Networking
M
Smallest Cheapest ASA/PIX

eBay is definately your best bet for good cheap Cisco gear. Tho the ASA might still be failrly expensive. You might want to consider a PIX if it runs a reasonably recent OS, they are fairly similar to the ASA in terms of commands.
- MulLa
- Post #4
- Jul 21, 2008
- Forum: Networking
M
A faulty Router?

Thanks jlazzaro! Now I can sleep better at night ;) Or at least until another issue crops up! But thanks once again to everyone.
- MulLa
- Post #15
- Jul 29, 2007
- Forum: Networking
M
A faulty Router?

Finally it's fixed!!!! Well as nightowl as suggested I checked the file size of some of the later IOS'es and one was 23MB in size so I thought I'd give that a try it was 12.4(11).T3 and now even with http & https inspection turned on it still downloads at the expected speed range. One last...
- MulLa
- Post #13
- Jul 28, 2007
- Forum: Networking
M
A faulty Router?

Thanks again for everyone's helps: heymrdj Understand that it might cause some slight performance degredation but it's probably a bit severe in my case and certainly not normal. nightowl Thanks for your self experimentation ;) I have updated my IOS to 12.4(6)T7 unfortunately my router...
- MulLa
- Post #10
- Jul 26, 2007
- Forum: Networking
M
A faulty Router?

Thanks everyone for your input! nightowl tried what you suggested started off with: ip inspect name fwall tcp router-traffic ip inspect name fwall udp router-traffic Then gradually build up, I found that whenever I enable either of the below ip inspect name FIREWALL http ip inspect...
- MulLa
- Post #4
- Jul 25, 2007
- Forum: Networking
M
A faulty Router?

Hi All, In relation to this earlier Thread I have since wiped the config and started all over again. Basically, the router is downloading from the net at dial-up speed for some reason. Having rebuilt the config, I found out that whenever I enable IOS firewall either through CLI or...
- MulLa
- Thread
- Jul 25, 2007
- Replies: 14
- Forum: Networking
M
"Disappearing" door Lincoln Mark VIII

Be good when idiots park waaaay to close to your door, you'd still be able to open your door and get in!
- MulLa
- Post #9
- Jul 10, 2007
- Forum: The Garage
M
Extremely Slow Download Speed

Anyone has any ideas? Rebuilding from scratch is going to be painful, especially I've forgotten what half the stuff does :P but sounds like the only option. :( Thanks in advance.
- MulLa
- Post #7
- Jul 10, 2007
- Forum: Networking
M
Extremely Slow Download Speed

Thanks heaps everyone for the assistance. Well the ACL's are in a mess coz I've started building this router when I was just starting out on Cisco experimentation and building overtime has created a mess :s There are no tunnel interfaces, I do have VPN setup over it but there were no VPN...
- MulLa
- Post #6
- Jul 7, 2007
- Forum: Networking

RESOURCES

Top Bottom