Fuggin-A, i'm lucky i got my store credit cashed in this summer. At least there was a warning shot before closing this next set of 100 stores. I keep wondering where the profit motive is, with corporate takeovers and mass-liquidations. CompUSSR bought the Good Guys chain, converted some to...
Rent a cow suit for $50, get your free combo, then sub-lease the suit to people standing in line for $2. Who wouldnt rent a suit for $2 to get a delicious meal?
Actually, i'd just go for the entree. Fries are filler & my closet is full of Cokes.
Trying to reinstall the HSF... couldn't get it to clip in so I used a screwdriver. SLIP - and the screwdriver tip jabbed into a tiny component next to the RAM slots
ouch. i'm shocked this hasnt happened to me at least 2 dozen times with those gee-damn Athlon HSF clips.
Zap: 1 = lack of signal while 0 = signal. AFAIK signal means voltage.
Or, signal could be represented by current, ie, if pin is grounded, current flows through it. It's been a while since i had to tie pins together, but i'm pretty sure 0 = Vss.
Zap: Which is it?
Potayto. (vid4-0) I think the mixup was me assuming default 1.2v for lower-speed Mobile Cel's. Maybe that only applies to Speedstep variants.
BTW, you can simulate the BSEL0 pin still being in place by duing the "wire trick" to connect BSEL0 to the nearest VCC...
Zap: according to one datasheet the mobile Celeron should default to 01001 but it doesn't "act" that way on a desktop board, thus I say 01010 is the way it "acts."
It acts as advertised on my GA-8IGX. The damn nail polish kept stripping off my pins, so ultimately i had to pop the s478...
Your 1.18 was probably 1.175 (VID = 11011). Grounding VID4 (01011) would give you 1.575, which shouldnt have killed your cpu. Connecting VID4 + VID3 would still give you 11011, since VID3 = "1".
If it only lasts 1 minute in Prime95, it will affect your daily use. You can find the temp limit from the datasheets at support.intel.com. Most of the p4-478's seem to say 100celsius, FWIW.
I tried my 2.4 cel + intel stock 478 hsf on a Gigabyte 8igx (845g) with some weirdness. First, i isolated VID4 with nail polish, and got the 1.225v i was hoping for (mobo allows up to +0.3v or so). Then, i LAN-booted linux (2.4.20 kernel) & ran mprime for about 30min before it rebooted...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.