Recent content by Sardian

S
SATA drive not working while FSB is raised?

Did you go into the bios and manually set the agp/pci bus to 66/33. I know you have a rev.1 board and it may not lock for you but even though I have a rev.2 board I still must manually set the bus to 66/33 or it isn't locked. You can use the program ClockGen to check if it is locked or not.
- Sardian
- Post #10
- Jan 7, 2005
- Forum: CPUs and Overclocking
S
Athlon 64 3000/3200+ can overclock as high as the 3500+?

3200+ 939 at 2.5ghz. On a Asus A8V. Stock cooling and voltage and as stable as a rock. It post fine at 2.60 but fails Prime and also crashes after about 30 minutes of HL2. At 2.5 it will run Prime all day and hasn't blue screened in the 2 weeks it has been running at this speed.
- Sardian
- Post #14
- Jan 2, 2005
- Forum: CPUs and Overclocking
S
Athlon 64 3200+ 939 owners, post your OC , voltage and temp readings

3200+ Winchester 939 running at 2.5ghz Htt4. My 1gb Corsair Value select is at 208mhz but I am getting over 6100mb/s in sandra with 92% bandwidth efficiency which I think is pretty good. I picked up a huge memory performance boost when I set the 2t to "disable" which enables 1t. Mem benchmark...
- Sardian
- Post #10
- Dec 28, 2004
- Forum: CPUs and Overclocking
S
How noisy/quiet is the Athlon 64 retail fan/heatsink?

My 3200+ A64 Winchester is running at 2.5ghz with the stock hs/fan, it is usually doing about 2900-3000 rpm. Even at this low speed my idle temp is 38c and under load it never gets above 45c. It is very quiet to me. My old 2500+ running at 3200+ speed had a hs/fan on it that sounded like a...
- Sardian
- Post #7
- Dec 28, 2004
- Forum: CPUs and Overclocking
S
Is my memory divider hurting me much

I have a ASUS A8V Delux with a 3200+ running with a HTT set to 4 and the fsb at 250mhz. I am using Corsair Value Select DDR3200 memory with the divider set to 5:3. This runs my memory at 209mhz which is about as high as I can get it using the dividers available. My question is, am I hurting...
- Sardian
- Thread
- Dec 25, 2004
- Replies: 1
- Forum: CPUs and Overclocking
S
Asus A7N8X-X makes high-pitched noise - HELP!

I had a board that made a sound like that once and once I took it out of the case and hooked it up it didn't do it any longer. I put it back in the case using insulators and that fixed it. On the a7n8x I had it would make a sound that was high pitched but it came out of the speakers. I...
- Sardian
- Post #8
- Dec 22, 2004
- Forum: Motherboards
S
Asus A8V SATA setup problems

A question for everyone having problems. If you are going to use one sata drive why don't you use the VIA SATA connectors? I did and my build couldn't have been better. I have a 3200+ A64 Winchester, A8V Delux, 1gb corsair, 1x74gb SATA Raptor hooked to the VIA SATA. I made a floppy from...
- Sardian
- Post #33
- Dec 22, 2004
- Forum: Motherboards
S
Help me overclock my 3200+ Winchester, Please...

I just put together a system using a AMD 3200+ Winchester 90nm, 1gb of Corsair Value Select, a 74gig SATA Raptor all attached to an ASUS AV8-Delux. The build went perfect with no trouble at all. I would like to overclock the processor, hopefully to 2.4 ghz and I know my Ram has no chance...
- Sardian
- Thread
- Dec 21, 2004
- Replies: 2
- Forum: CPUs and Overclocking

RESOURCES

Top Bottom