is it a decent board for oc? i'm looking to upgrade from an msi 645 board as this board pretty much tops out @ a 133 fsb (designed for 100) and i'm getting sorta tired of waiting for the dual channel ddr solution. anyone with any experience with this board? good? bad?
this may be ot but
if you have a couple of fans blowing in clean air (i.e. filtered) and some blowing air out, if your incoming cfm is higher than your outgoing cfm then it should cause enough pressure to build up inside the case to start blowing out all the little cracks and crevices. and...
the only things you need hooked up are the ps, the processor, and ram. i do this when i have a problem and need to check components.
i ran my whole set up laying on my floor for about a week once while i was tinkering with the case. didn't hurt a thing : ) and i think it kept my processor a...
i just think the whole idea of paper launches is funny, this just being the latest incident of it so i thought i'd say something and see what you all think.
i mean really tho what's the use of saying "here have a look at our latest product" if you can't get it to consumers? that's not a...
they "release" (or was it "announce"?) the xp 2400+ and 2600+, but then don't bother to sell them? what did they do build them just so they could say "hey this is what we have, don't buy someone else's stuff because we have better. oh, well we're not letting any out but we have it" lol. just...
i've seen a few motherboards offering serial ata support, but is this really going to be useful before you would need to upgrade again? i mean will there be drives available within the next 6 months? it seems like a tempting piece of technology, especially by getting rid of the damn ribbon...
i would say make sure you have all your drivers installed, agp, etc. i clicked on your link and it says n/a for the lower half of the tests on your side, and i don't think there's any way my nature score should be higher than yours since i'm running a non oc'd original gf 3. here's my link...
i wouldn't concern myself too much with performance of chipsets right now, as intel is planning on releasing a dual channel ddr chip within the next 6 months or so (i think), so get a good chip, decent board, good ddr ram. once you go dual channel with ddr then your bandwidth should well exceed...
to someone who owns the aluminum version of the 10xx tower, is the whole frame made of aluminum? specifically the front part with the fan grills and the rear part w/ fan grills? or are those two panels still made of steel?
i'm trying to figure out which one to get. i love this series of...
i have an alpha for the p4 which is basically the same design. the quality isn't as good as the top of the line swiftech IMO but it's still a good heat sink. i slapped on a 50 cfm fan and noticed ZERO temp difference than with my 24 cfm panaflo, so i switched back. currently have the panaflo...
according to some charts i've looked up and a little bit of experimentation, doint the 7v mod to your fans will reduce rpm and airflow by approx 40%.
not positive about rpm but according to sanyo denki's website at 7v you will have approx 60% the airflow of 12v.
all this in the name of...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.