boot with start up disk, run fdisk, partition and format. it should see it fine then. unless you ahve special programing, you can not have the operating system on the master and the slave unit.
with some usb devices, you have to load the software before you attatch the device. also look under control panel-tweak ui and see if extra drive letters ahve a check by them.
Look and see if you have treak ui in your control panel. If you do, look under paranioa tab and make sure that CLEAR LAST USER is unchecked. That shouls solve your problem.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.