Recent content by shezan

S
The **OFFICIAL** GMAIL Thread

I'm looking for a G-MAIL account too! If anyone could be as kind, i'd REALLY appreciate it. shezanc@hotmail.com. I shall perform sexual favours... or brush your hair.... ahem.
- shezan
- Post #6,547
- Jul 21, 2004
- Forum: Hot Deals and Giveaways
S
-= NEED SOME QUICK help PLEASE with choosing OCZ RAM (gonna pick up in a couple hours) =-

How about the Enhanced Bandwidth DDR433. Would it serve me well over platinum edition and gold rev 2? - Shezan
- shezan
- Post #4
- May 27, 2004
- Forum: CPUs and Overclocking
S
-= NEED SOME QUICK help PLEASE with choosing OCZ RAM (gonna pick up in a couple hours) =-

Hiyo, Looking to pick up one stick of 512MB RAM in a couple hours. It will be single channel, since I don't see the point in spending an extra 40 CDN for 2-3% increase in performance (Will be grabbing a mobile XP 2500+). I just need some advice on RAM, it will most likely be OCZ. Mostly like...
- shezan
- Thread
- May 27, 2004
- Replies: 8
- Forum: CPUs and Overclocking
S
Advice/Comments on NEW SYSTEM

I was thinking about getting the Enhanced Bandwidth but I wasn't too sure if it would make all that much of a difference in my case since I'd be O/C to a 3200+. I thought EL would do the job. And I actually want to get a 1 GIG pretty badly, but the double cost is way out of my budget. If I...
- shezan
- Post #4
- May 26, 2004
- Forum: Computer Building
S
Advice/Comments on NEW SYSTEM

Hello kids, adults, and anything in between: Getting my parts for my new system tommorow, just need some feedback about the parts listed and some questions answered. Bare with me since I know the parts listed here is bassically 90% of the users on AT forums. - AMD Barton 2500+ - Abit NF7-S...
- shezan
- Thread
- May 26, 2004
- Replies: 3
- Forum: Computer Building
S
HOT SWAPPING A BIOS

Nope, my bios didn't seem to have the boot block, cus it didn't seek the floppy drive. That's why i wanted a hot swap. However, my uncle's comp store turned out to have an Amptron mobo with the same chipsets and same bios distribution, just diff model. I tried his bios chip in mine. I didn't...
- shezan
- Post #8
- Apr 14, 2004
- Forum: Computer Building
S
HOT SWAPPING A BIOS

Need help with hot swapping my bios chip I tried to flash my system with this supposedly proper bios revision for my board from ZDNET (mainly cus my board wasn't running my 9800 radeon, and the latest revision on my board's site is from the stone ages). It said it was good but when i restarted...
- shezan
- Thread
- Apr 14, 2004
- Replies: 7
- Forum: Computer Building
S
Computer WONT POST... HELP!!!

bump... is there any tricks to get the willamete processors running with an fsb of 133mhz? - Shezan
- shezan
- Post #11
- Mar 25, 2003
- Forum: CPUs and Overclocking
S
Possible problems with OC TB 2100+?

Also, if you haven't downloaded the via drivers, download them! If you don't have em, no tweak would help until you have them installed.
- shezan
- Post #3
- Mar 24, 2003
- Forum: CPUs and Overclocking
S
Computer WONT POST... HELP!!!

bump...
- shezan
- Post #10
- Mar 24, 2003
- Forum: CPUs and Overclocking
S
Computer WONT POST... HELP!!!

Yea, duvie, you are right... it is a willamete is there anything i can do? like a trick to unlock the cpu or something to get my system running at 133mhz??? Thanks - Shezan
- shezan
- Post #9
- Mar 21, 2003
- Forum: CPUs and Overclocking
S
Computer WONT POST... HELP!!!

You should be able to... then why would the motherboard manufacturer even bother to put a 100/133mhz bus selection as jumpers... wouldn't make sense to put it there if the board didn't offer it.
- shezan
- Post #7
- Mar 21, 2003
- Forum: CPUs and Overclocking
S
Computer WONT POST... HELP!!!

bump...
- shezan
- Post #4
- Mar 20, 2003
- Forum: CPUs and Overclocking
S
Computer WONT POST... HELP!!!

Hi, Yup, i tried putting it back to 100mhz, and it booted fine. And yea, i reseted the cmos by both taking out the lithium battery for 5 minutes w/ all power turned off. And also by reseting via the jumpers, to no success. - Shezan
- shezan
- Post #3
- Mar 18, 2003
- Forum: CPUs and Overclocking
S
Computer WONT POST... HELP!!!

Hi, My current setup is a Pentium 4 1.6Ghz processer, 2 x 256mb sdram pc133 sticks (512 total), Geforce 4 ti4200, 1 3com NIC, Soundblaster Audigy, 1 30 gig and 1 60 gig (both dma 100 capable). My mother is made by some company called amptron, http://www.amptron.com/html/p4_920LSD.html <--- my...
- shezan
- Thread
- Mar 17, 2003
- Replies: 11
- Forum: CPUs and Overclocking

RESOURCES

Top Bottom