Thanks, everyone. I actually flipped the ports that night and got everything up and running. 35C idle and 50C load on both cards now. I just haven't been able to get back in and update this thread since then.
I've got a watercooling loop that cools an i5 2500k and two GTX 570s (one ASUS DirectCUII and one Reference).
Before I added the ASUS, the Reference card would hit about 45C under furmark, while the CPU would hit 60 under prime (furmark and prime both open).
My loop is now...
Using a CM 692. I don't have pics, but basically one 240 in the top, one on bottom, and the proposed location for the 120 is in the front.
Good point.
I think I'll just stick with the setup I have now and exclude the passive radiator. I chose blocks/rads with low restriction, so the...
I was afraid of that, too. The rad would be mounted vertically in the bottom front of the case and there would be a 240 rad with 2 120x38 Panaflos at the bottom only a few cm away.
I've also got two San Aces at the top exhausting and one in the back drawing in air. Would the amount of air being...
EDIT: Based on input and consideration, I'll just leave loop as is.
OP:
I've currently got an i5 2500k and two GTX 570's on a single loop with two 240mm rads and an MCP35X pump.
res->pump->rad1->gpu1->gpu2->rad2->cpu->res
I've yet to fill the loop (just drained and added a second...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.