Well i have the same vcore problem, my games freezes everytime the vcore dips down too much on load. I have to set it at 1.80 at bios, so when its full load it dips to lowest at 1.68 and idles at 1.78 and these are from motherboard monitor. That the only way i can stay stable at 154 fsb 4:5...
I have that problem also, it drops to the point where my games gives me errors or lockup. Now i'm running prime 95 to help me determine whats the prob. So far so good at vcore 1.8 at bios, in windows it idles about 1.78, under load its at 1.70. So far its passing prime at 2 hours.
P4 1.6A (Costa Rica 6/5/02) @2.52ghz
158mhz FSB
4:5 Mem ratio
394 DDR speed
512mb Samsung on powmem pcb CAS 2.5 6/3/3
1.72 Vcore
2.7 Vdimm
I can go up to 400 ddr speed now that i have a new 520 watt ps. But I don't want to bump up the voltage for it to get stable.
I am using 2.5/6/3/3 for my rams, so far i'm rock stable at 157 fsb 4:5 mem at 1.750 volts 2.8 dimm volt. Dont wanna push it to 160 fsb and up the volts to 1.80 just to get it stable.
Thanks for that comment crapito or i wouldn't even tried 4:5, because i thought i was limited by my rams samsung pc2700 on powmem pcb. On 3:4 i can only get to 143 fsb, while on 4:5 i was able to get to 160 fsb and it runs stable. Thanks
Hey guys just wondering, in motherboard monitor it shows my 3.3 at 2.77, is that goingt o be a problem? is that agp voltage? Or is the 4g4a+ just displaying the wrong #. Thanks
Nevermind i saw what anazoal posted. But was wondering if i need a new powersupply guys, i have an antec 350w ps...
Yea mines is locked at 33/66 and using a antec 350 ps, if i move the fsb to 146 and over, it will do hang at in black screen also, this is with 3/4 mem ratio.
Anything i have in slot 1 regardless of having one in slot 2/3 or not, it will hang in black screen with nvidia drivers anything higher then around ddr337 and higher. If i use one in slot 2 and 3 its fine but since i have both double sided samsung 333, guess i have to use only one.
Does that...
Hey metro i think i had a similiar problem like yours, when i install new drivers for winme and winxp it would just hang when it loads up in black screen. The way that i solved it is not using your rams in the first slot that it doesn't share resources, i had to use the ones that are shared two...
Thanx guys i'll try that l1 pencil thing and see if i can get it to work, for now it will be geforce 2 mx, i'll overclock it , doubt he would want to spend more on a video card. Thanks again
Yes it is a morgan chip and the p3 is a 700e@933. Thanks for the quick response. I'm just wondering if the ddr would make a difference at all and its probably gonna run at 200mhz since thats what the duron supports. Would it be a big difference ir not i'll just give my friend the p3 with sdrams.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.