I have the same board, with 8gb installed.
The only way it will run is with mem volt at 2.42. Everyone says its too high but its been that way for a while. I'm gonna mess around in the bios and see if I can get it to run at a lower voltage.
There's really lag or real wait time as it is, but I just wanted "to go faster".
I may just way a while longer since you guys don't really see it being worth the upgrade.
I think I will get a new mb and psu though. My vcore fluctuates from 1.24v loaded to 1.36v at idle. That doesn't seem...
My current setup is in my sig.
I installed cpu-z and my CPU voltage is going from 1.24-1.36v.
I don't understand why it would fluctuate so much, so it doesn't seem right to me.
My voltage is set at 1.25 in the bios and c1 stepping is disabled.
I guess I will go 750w modular if this...
I think the harddrive setup is pretty good. I'm using two Sata 300 640gb drives Raid 0 and reading from those writing to my sata 300 1tb drive it usually transfers in the 90mb/s range. 97mb/s is the fastest I've seen. Raid made a huge difference.
My system is in my sig.
I'm thinking about getting a new CPU. Would a Q9650 overclocked be worth the upgrade?
I don't game a lot, it's occasional.
I do a lot of multitasking and just like to have a fast computer.
If that CPU isn't worth the upgrade, would anything be a...
I tried to go higher. It boots at 3.30ghz and 1.33v but when it tries to load windows it says hardware or software has changed and something about kernel missing or changed. I tried 2.91 but it keeps rebooting. I tried messing with voltage and never got anything stable.
I know hardly anything about ram and timings and all that.
My computer scores 5.9 on all of the Windows Experience Index test in Vista except for ram. Ram is 5.7
Here's my setup.
Q9300 @ 2.85ghz
Asus P5N-E
8GB DDR2 800mhz Centon
2 x 640gb WD's Raid 0
I've seen a few of my...
It seems like I can never get my Q9300 system stable at anything above factory speeds. I finally got it in windows a while back and used it for a while at 3.30ghz but it was never real stable.
I would like to get my system to run at anything over 3ghz and be stable and I'd be happy.
I...
I can't get my computer stable with 8gb of ram installed.
I looked on Centons site, they say the ram runs at 1.81v. The lowest my MB has is 1.92 and it won't even boot at that. Any suggestions would help a lot.
My MB is an Asus P5N-E and the ram is Centon 4x2gb 800mhz ddr2.
Is...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.