My previous CPU was a 2.4C and I had it as high as 3.0 in an Asus P4P800
I think my my memory (2x512 Kingston ValueRAM PC3200) was keeping me down because towards the end I kept getting random reboots and I coudln't get it stable past 3.1
I don't own a DFI Ultra-D, but I've heard that it's one of the favorite boards for Overclockers right now. If you don't plan on overclocking, could you perhaps save a little bit of money by buying a slightly cheaper board?
I ran out of zip ties when I was arranging my cables and I used small rubber bands instead. It kinda looks ghetto, but they get the job done. I hate messy cables whether it'd be inside the case or outside power cables.
To change the multiplier on BIOS, is the setting to change it "Ratio CMOS Setting"? I can change that value and above that, option "Ratio Actual Value" is set to 14.
EDIT: Nevermind. I found out that's not it.
I have 2 extra 120mm Panaflo case fans. I'm gonna try to put one on the clear side panel of my case blowing in right over the HSF. Hopefully that will help.
Running WCPUID does not list the CPU as an ES. I took a screenshot of CPU-Z & WCPUID side by side but I can't figure out how to insert a picture into this board.
Anyways, I was thinking in getting a retail 630. I hope my Asus P5GDC-Deluxe can support that CPU. I'll have to check the mobo...
My CPU now idles at 42 degrees. It's getting closer to the 30's which is where I want to have it. I decided to sell it and just buy a retail Prescott. That way I won't have that tought in the back of my mind of whether it's an ES or not and if it's causing me problems. I don't need an ES if it...
Bummer! I'm also asking around in 2 other boards at the moment, and I think the consensus is pretty much to try a better/newer HSF. My case has good enough air case in my opinion. I have the Thermaltake SViking VA400BWS. I use SATA drives, so there are no big cables blocking the air and I also...
Okay, I ran TMPGenc and prime95 at the same time for about 5 minutes so far and the CPU load was at 100%. The CPU temp ranged between 62-64 during those 5 minutes. I also ran Throttlewatch at the same time and the TM1 Throttling never went up. Should I run them longer or is that good enough to...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.