NSE7_SDW-7.2 Practice Exam Questions and Answers

A.  

It simplifies the deployment and administration of SD-WAN on managed FortiGate devices.

B.  

It improves SD-WAN performance on the managed FortiGate devices.

C.  

It sends probe signals as health checks to the beacon servers on behalf of FortiGate.

D.  

It acts as a policy compliance entity to review all managed FortiGate devices.

E.  

It reduces WAN usage on FortiGate devices by acting as a local FortiGuard server.

A.  

Create a new firewall policy, and the select the SD-WAN zone as Incoming Interface.

B.  

In the traffic shaping policy, select Assign Shaping Class ID as Action.

C.  

In the firewall policy, select Proxy-based as Inspection Mode.

D.  

In the traffic shaping policy, enable Reverse shaper, and then select the traffic shaper to use.

A.  

SD-WAN rules use SLA targets to check if the preferred members meet the SLA requirements

B.  

Member metrics are measured only if an SLA target is configured

C.  

When configuring an SD-WAN rule you can select multiple SLA targets of the same performance SLA

D.  

SLA targets are used only by SD-WAN rules that are configured with Lowest Cost (SLA) or Maximize Bandwidth (SLA) as strategy

A.  

System template

B.  

BGP template

C.  

IPsec tunnel template

D.  

CLI template

E.  

Overlay template

A.  

Interface-based shaping mode

B.  

Reverse-policy shaping mode

C.  

Shared-policy shaping mode

D.  

Per-IP shaping mode

A.  

The sdwan_service_id flag in the session information is 0.

B.  

All SD-WAN rules have the default setting enabled.

C.  

Traffic does not match any of the entries in the policy route table.

D.  

Traffic is load balanced using the algorithm set for the v4-ecmp-mode setting.

A.  

update-source

B.  

set-route-tag

C.  

holdtime-timer

D.  

link-down-failover

A.  

It creates redundant tunnels between hub-and-spokes, in case failure takes place on the primary links.

B.  

It dynamically assigns cost and weight between the hub and the spokes, based on the physical distance.

C.  

It ensures that spoke-to-spoke traffic no longer needs to flow through the tunnels through the hub.

D.  

It provides direct connectivity between all sites by creating on-demand tunnels between spokes.

A.  

hold-down-time

B.  

link-down-failover

C.  

auto-discovery-shortcuts

D.  

idle-timeout

A.  

You can manually define the SD-WAN members sequence number.

B.  

Interfaces of type virtual wire pair can be used as SD-WAN members.

C.  

Interfaces of type VLAN can be used as SD-WAN members.

D.  

An SD-WAN member can belong to two or more SD-WAN zones.