1.11v to cpu. power supply?

[imported_Slash]

I use an msi neo2 nforce3 plat ultra with a 3200+ cpu and Ihave had some troubles over clocking so I installed mbm and found that I only have 1.11 volts to the cpu which is setting off the alarm.

Do I need to replace the power supply or the mainboard having issues?

 

[stevty2889]

Software monitoring of voltages is never very reliable. Are you having any stability issues? Do you have cool and quiet enabled? I wouldnt' be worried about what MBM says if you aren't having any problems..

 

[sodcha0s]

check hardware monitor in the BIOS, that will tell you what your vcore actually is.

 

[imported_Slash]

Yeah I did get the reading from the bios as well and replaced the power supply with an antec case including the 380watt power supply with a 24 amp 12 volt rail and that should cover it. Now I have 1.450v and a steady 12v rail that actually reads 12.09 volts in the bios and reads correctly with mbm.

The old power supply has been around for quite some time with many miles. Was time to upgrade!