DES-1721 Practice Exam Questions and Answers

You want to create a notification setting to help monitor how full the volumes are on an SC9000 system. In Dell Storage Manager (DSM), where would a schedule to only trigger these alerts during business hours be set up?

A customer is running the Dell Storage Manager (DSM) Suite as a software stack on Microsoft Windows. To reduce the Microsoft licensing costs, the customer wants to switch to the DSM Virtual Appliance.

Which recommended deployment should the customer use?

Refer to the exhibit.

Which port on the second SC280 expansion enclosure is used to connect the first expansion enclosure to the second expansion enclosure on the A-side of this configuration?

You are going to install a SC Series running SCOS 7.3.x with 15K and 7K disks. What Data Reduction option will be available on this system?

You are trying to discover a brand new SCv3020 but the process if failing. DHCP is not available. What is the best solution for this issue?

To allow the Storage Center Update Utility (SCUU) to serve updates, which inbound TCP port should be opened on the Microsoft Windows firewall?

Which command is used to set the eth0 IP address on an SC4020 controller?

When a SC is in a failover state what will occur in the surviving controller?

A customer wants to configure a threshold alert definition. Which types of definitions can be configured?

Refer to the exhibit.

The servers are zoned to best practices. The output of the switch is shown below:

Which is the Physical Zone of Fault Domain B?

During the initial installation of a new SC9000 Storage Center, which Dell Storage Manager (DSM) Client option should be selected?

What information should be considered when planning for storage performance requirements?

What is the correct sequence of steps to enable MPIO on a Microsoft Windows 2012 Server?

Which SC Series array feature allows all front-end ports to act as active data paths?

A customer has a dual controller system, two independent Fibre Channel switches, and six servers all multipathed. How many zones should be present on each for the SAN to run properly in Virtual Port Mode?

How many SAS ports are used on each EMM of an SC460?

You are implementing a front-end connection in Legacy Port Mode on an SC4020 16 Gb FC array with two FC switches. Can full redundancy be achieved and if so, how many ports per switch can be used by the SC Series array?

How many SC420 enclosures can be supported by the SC7020 controller?

You just finished racking a SC7020 array. After powering it on, you notice there is no indicator LED on the front or back of the array, but the fans are spinning.

What could be the cause?

You have implemented two SC Series systems at a customer site. The Dell Storage Manager (DSM) Suite has been installed on a Microsoft Windows server. Both Storage Centers have been installed and added to the DSM. However, several days after the installation, the customer is only able to see one Storage Center in the DSM GUI.

Which recommended action will correct this issue?

Assume a storage administrator is using the recommended storage profile. What describes the distribution of volume data residing in an SC series storage array that has 15K and 7K as the back-end?

What three core features are part of the protection bundle?